The best foam insulation company in Riyadh 0500707706
Steps to isolate surfaces using a foam polyurethane insulation company in Riyadh: When you use any foam insulation company in Riyadh or a foam polyurethane insulation company in Riyadh, you must follow the following first: 1 - Clean the surface to be isolated from dust and dust by air pressure. 2 - Putting materials that consist of polyol and acocyanite in its machine and adjust it according to the required density and thickness. The thickness ranges between 2.5 cm to 5 cm and the density has several measurements starting from 35/40 and 40/45 and 45/50 and 55/60 . 3 - Spray the polyurethane material over the surfaces to be isolated evenly and at a distance of approximately one meter from the spray gun until the required thickness is reached and the surface is completely covered. 4 - After the completion of any foam polyurethane insulation company in Riyadh from the spraying process, an acrylic insulation material is prepared and the acrylic insulation paint is applied over the foam layer using a roller to protect against ultraviolet radiation. This layer also helps to double the thermal insulation of the surfaces. Among the advantages of using any foam insulation company in Riyadh is the following: 1 - Foam insulation in Riyadh is hydrothermal insulation, and therefore it is used by any foam insulation company in Riyadh because it saves money and time on other types of insulation, which when you use it only requires two types of waterproofing and thermal insulation only. 2 - Isolation of foam in Riyadh with fast adherence on insulated and fast drying surfaces, and with the passage of time, its strength and strength increase. 3 - Isolating foam in Riyadh does not leave any place on the insulated surface that cannot be reached, even pores and small holes. The method of isolating with spray reaches its smallest and permanently blocks it. 4 - Insulating foam in Riyadh and acrylic layer resistant to sunlight and against corrosion for many years exceeding 10 years and in some thicknesses and density up to 15 years. 5 - Insulating foam in Riyadh can be used on any type of surfaces, whether concrete, shinko, or brick. Foam insulation in Riyadh: In those videos, you can see some of the polyurethane foam insulation work in Riyadh for some of our works on concrete, shenko, and brick surfaces, which were made by any of the El-Beli company which is the best foam insulation company in Riyadh. Al-Bailey is distinguished as the best foam polyurethane insulation company in Riyadh as well, and one of the best foam insulation companies in Riyadh in general.
2019-12-08
Visits : 1065
Comments
: 0
Share :